How to install No Noise LED Light from VocalBoothToGo
Vocal Booth To Go LED light for Vocal Booths includes following parts:
1 LED light with on/off switch;
1 Power Adaptor;
1 Mounting bracket consisting of brackets itself and special screws and nuts (3 each).
Bracket assembly instructions
To attach bracket to the light follow these steps:
1. Insert special screws into the groove on the back of the light; Slide in as you insert all three:
2. Lay the bracket over the screws then secure with nuts:
Please note: Light direction can be adjusted by turning the light within bracket slots:
Practical use and installation:
Wall Mount
The LED light can be attached to a wall or under a counter or anywhere you need to use the light. Here are examples of wall mount:
Center support:
Corner support and under counter:
LED light installation in a Vocal Booth
When installing LED No Noise Light in our Mobile Booths, use of included brackets is not required.
For AVB Booths, simply place the light on the frame where it is convenient. Zip ties or Velcro tie ups (not included) can also be used to secure the LED light on the frame.
For SPB Booths, slide the LED light on the frame bars under the roof panel.
For more permanent installation you can use the supplied bracket and just screw it to the frame.
Here are some LED light installation examples:
Zip ties attachment:
Velcro tie ups:
Bracket screwed to the frame:
If you require any assistance with No Noise LED light setup, please contact us at any time: support@vocalboothtogo.com